

“Example service started at …” line does not appear in the output of the status command.May 02 15:03:07 localhost systemd: Starting Example systemd service. May 02 15:03:07 localhost systemd: Started Example systemd service. ├─2973 /bin/bash /usr/bin/test_service.sh Loaded: loaded (/usr/lib/systemd/system/rvice enabled vendor preset: disabled)Īctive: active (running) since Wed 15:03:07 UTC 48s ago You should see that the service logged its start time immediately after booting:

Reboot your Linode from the Linode Manager and check the status of the service: sudo systemctl status myservice The service can be stopped or restarted using standard systemd commands: sudo systemctl stop myserviceįinally, use the enable command to ensure that the service starts whenever the system boots: sudo systemctl enable myserviceĬreated symlink from /etc/systemd/system//rvice to /lib/systemd/system/rvice. May 01 18:17:14 localhost cat: Example service started at 18:17:14
NEOROUTER LINUX START ON BOOT HOW TO
What am I doing wrong and how to solve the problem Systemd files in /.config/systemd/user. May 01 18:17:14 localhost systemd: Started Example systemd service. Task: Start Firefox on startup Linux (Ubuntu 18.04 LTS) Problem: I think the problem is that I want to start a GUI program. Loaded: loaded (/lib/systemd/system/rvice enabled vendor preset: enabled)Īctive: active (running) since Tue 18:17:14 UTC 4s ago If the service is running correctly, the output should resemble the following: Once you have a unit file, you are ready to test the service: sudo systemctl start myserviceĬheck the status of the service: sudo systemctl status myservice Sudo chmod 644 /etc/systemd/system/rviceįor more information about the unit file and its available configuration options, see the The critical part is the ExecStart directive, which specifies the command that will be run to start the service.Ĭopy the unit file to /etc/systemd/system and give it permissions: sudo cp rvice /etc/systemd/system/rvice

ExecStart=/bin/bash /usr/bin/test_service.sh
